Known KMotionCNC CAD/CAM Post Processors

Mechsoft

http://mecsoft.com/freemill/

Hi Tom,

 

After much digging, I did find a post processor file in the Freemill site and it seems to work! 

 

Just an FYI:

The (freemill) instructions installing it were not accurate so if you run into this in the future the processor is downloaded at :

http://mecsoft.com/PostProcessors/MILL/kmotion.spm

 

And then the file is installed into

C:\ProgramData\MecSoft Corporation\VisualCAM 2014\Posts\MILL

 

Thanks for your rapid reply!

 

Troy

AutoDesk Fusion 360

See this post

https://forums.autodesk.com/t5/fusion-360-computer-aided/tool-parameters/td-p/5711808

Also this post

http://www.cnczone.com/forums/dynomotion-kflop-kanalog/343726-posprocessor-fusion360-kflop.html#post2086576

Test.txt