Mechsoft
Hi Tom,
After much digging, I did find a post processor file in the Freemill site and it seems to work!
Just an FYI:
The (freemill) instructions installing it were not accurate so if you run into this in the future the processor is downloaded at :
And then the file is installed into
C:\ProgramData\MecSoft Corporation\VisualCAM 2014\Posts\MILL
Thanks for your rapid reply!
Troy
AutoDesk Fusion 360
See this post
Also this post
Alexander (Александр Украинец) contributed two Posts. One for Mill and one for Lathe (the .txt extension should be removed)