Page 1 of 1
plasma cutting machine
Posted: Thu Jan 20, 2022 8:14 am
by irmad
hello,
now i want to make a plasma cutting machine. what products from dynomotion should I buy? certainly KFLOP and there are other additions.
Re: plasma cutting machine
Posted: Thu Jan 20, 2022 5:17 pm
by TomKerekes
That would depend on your design.
Re: plasma cutting machine
Posted: Sat Jan 22, 2022 9:34 am
by irmad
I need 3 axis, X Y Z. plan X and Y using stepper motor Nema 34, and Y I'm not so sure, what's your suggestion for Z axis about motor? do they all have to be the same? then what board should I buy?
Re: plasma cutting machine
Posted: Sat Jan 22, 2022 5:19 pm
by TomKerekes
If you obtain Step/Direction Motor Drivers those can usually be driven directly by
KFLOP.
If you need to input analog voltages such as Torch Voltage you might add
Kanalog.
If you need more isolated IO you might add one or more
Konnects.
Motors don't need to be the same.
Re: plasma cutting machine
Posted: Tue Apr 12, 2022 7:53 am
by irmad
is there an update for the kmotionCNC software, sir?
Re: plasma cutting machine
Posted: Tue Apr 12, 2022 5:12 pm
by TomKerekes
Latest Test Release is
4.35f