simulate

[IvanSiberia]

After executing the G code in the simulation, the tool from the G code remains selected in KMotionCNC. How can you leave the initial tool after the simulation?

[TomKerekes]

Hi Ivan,

We currently don't have such an option. Whatever execution of the code does to the Interpreter occurs as if the GCode was executed. I suppose such an option could be added.

I think it is best practice to have the GCode specify which Tool is to be used and not rely on the previously selected.

[IvanSiberia]

is there a flag that the simulation has ended or started?

[TomKerekes]

No. Internally there is a variable m_DoingSimulationRun but you would need to change KMotionCNC source code to have access to it.

[IvanSiberia]

thanks, the solution works