Shortcuts to Kmotion Axes Jog for B, C, U, V

[AmitKumar171]

Hi All,

I am using KMotion Board. And in KmotionCNC software there are jog buttons are there respectively for X, Y, Z, A, B, C axes.

And Shortcut Commands are there for Step/Fast Jog Only 4 of 8 axes. like X, Y, Z, A.

How do i add more shortcuts to drive axes like B, C, U, V to Step/Fast Jog similar to Ctrl+Jog or Shift+Jog Keyboard Shortcuts. ?

Please help me in with this regards.

[TomKerekes]

Hi Amit,

We only have Jog Buttons for XYZABC. You can assign Hot Keys for the BC axes with the Screen Editor. All 3 buttons for the axis direction must be assigned the same Hot Key.

We don't have Jog Buttons for the UV axis. You could do basic Jogging of those axes using a momentary button to set a Virtual Bit. Then create a C Program to monitor the Virtual Bit and Jog the axis when the bit turns on and stop the axis when the bit turns off.

[AmitKumar171]

Hi Tom,

Thanks for the reply as you have said earlier I did edited KmotionCNCscreen editor to use DIVIDE KEY and MULTIPLICATION KEY to set keyboard jog for my c axis. I have set the key according to the sceenshot attached. But i am not able to run the C axis with above keyboard buttons.

Is there any other changes than screen editor

Hot keys 111 and 106 respectively. I want to set those keys to jog my C axis similar to X,Y,Z,A. As in picture i already set it in screen editor but it is not working.

Please help me to add a jog button for C axis.

Waiting for your kind reply.

[TomKerekes]

Hi Amit,

It seems to work fine for me.

Did you set all 3 buttons to the same hotkey?

Did you push the "Set" button?

Is "Keyboard Jog" enabled?

Are there any duplicate Hot Keys defined"

Attached is a working example.

[AmitKumar171]

Hi Tom,

Thanks for your reply.

I have done that. and i have seen your post in that KmotionCNCdlg file there is an option to set axes from 4 to 6 then it will work.

And it is working fine to me.