SETTING UP KFLOP, KANALOG FOR NEW CNC ROUTER RETROFIT

[NOELNOG]

Hi Tom

Is there a function to watch the value of the axes read outs, for example when performing tool change, if the X axis moves 70 inches near magazine, do the next step and continue, but if for any reason the axes doesn't get to 70 inches the tool change operation must stop, is any function to add to the atc c. program for that?

regards

[TomKerekes]

Hi Noel,

Its not clear what you are trying to achieve. Normally if you command an axis to move you will wait until it is completed.

Do you have encoders? If so and the axis doesn't move properly you should get a following error.

You can monitor the commanded position in counts as ch->Dest and the actual Position as ch->Position.

HTH

[NOELNOG]

Hi Tom

How can i enable the A or B axis to tangential, i have a spindle with rotary aggregate for use with saw blades, and 90º cutter bits.

regards

[TomKerekes]

Hi Noel,

You might see the Tangent.c example.