SETTING UP KFLOP, KANALOG FOR NEW CNC ROUTER RETROFIT

[TomKerekes]

Hi Noel,

Actions to be associated with those buttons can be assigned in the Tool Setup. See here.

However the Stop action is performed after disabling the Axes so a "Controlled Stop" would not be possible. The idea is that the Stop Button should only be used in an emergency where a controlled stop may not be possible or successful, otherwise use Halt. If you wish to do this then you might replace the Stop Button with a custom button to do whatever you wish.

[NOELNOG]

Hi Tom

What is the function of the reset pin #4 on JP7, JP6, JP4 ?

best regards

[TomKerekes]

It is an output that can be used by User Hardware.

[NOELNOG]

Hi Tom

does kflop and konnect works with Mach 4 ?

regards

[TomKerekes]

No