Simulation timer

[Tarasevih]

Hi Tom.
Thanks a lot Tom.
Filmed some video.
https://www.youtube.com/watch?v=wPZ8Waht-QU
Could you tell me what is the name and where to look for the simulation time variable ?
I'll take her out myself.

Regards,
Taras.

[TomKerekes]

Hi Taris,

Did you see my post?

Here is a Version with the KMotionCNC path name abbreviated to always fit in the title bar and allow the Job Time to always be visible. It also supports hovering over the title bar to display the full unabbreviated path name possibly on multiple lines.

V5.2.1

The Do Times results are saved in the KMotionCNCDlg Class in variables:

JobDoTimeSecs
JobDoTimeValid

[Tarasevih]

Hi Tom.
Thanks a lot Tom.
Yes Tom I carefully read your messages.
I was only able to check today.
https://www.youtube.com/watch?v=PHyLsKOtne4
It seems to me that the viewport does not respond to changing kinematics.
And continues to draw along the x-axis.
A variant with the replacement of the A axis with the B axis is working.
Thanks for the details about the simulation time.
Regards,
Taras.

[TomKerekes]

Hi Taras,

I don't understand what you mean.

Please do not post videos without an explanation of what you are trying to show.

The GViewer only plots the XYZ tool tip path specified in the GCode. The Kinematics won't have any effect.

[Tarasevih]

Hi Tom.
Sorry Tom.
I did what you asked.
In general, thank you very much for your attention.



Regards,
Taras.