Toggle Button and low high bit

[GabrielR922]

Hi Tom,

Is there a way without a c program to make a toggle button ?

When the button is pressed certain bit goes high if it was low or goes low if it was high.

Thanks.

[TomKerekes]

Yes see Video

[GabrielR922]

Thanks Tom, that was what I needed.

[Rasta]

HI Tom;
I have followed the directions in the Toggle button video , and yes I can modify the buttons , but after I exit KmotionCnc , and fire
it back again ,the buttons or anything that I have done is no updated , can you please tell me what im doing wrong?
Regards
Mariano

[TomKerekes]

Hi Mariano,

Are you writing the modified Screen Script?

[Rasta]

Yes , I have renamed the screen Wire Edm .scr
On the main tab I select the screen script Wire Edm.scr
Then go back to the Control Select screen and to just try it , modify the 46 Momentarily button , by changing its name to Main Pump, then I observed that the name Main Pump, appears on the button now . After that I closed the screen editor , and
Also closed the Kmotion CNC ,
Then fire up Kmotion CNC and observed that the button that I have modified previously ,is back to its original setting ( 46 Momentarily ) instead of Main Pump,
Please help
Mariano

[Rasta]

Please disregard my last message
I found the problem ,
I did not Write the script , silly me
Thank you for your help

Mariano