GCode Viewer

[vicv]

Hi Tom and Sascha,

I am new to this forum so just trying to work out its functionality and etiquette.
I have some questions after doing some reading and tinkering.

I have Kflop connected and have worked out the basics of the screen editor. Two issues are unresolved for me at the minute
1: How can I run a program slowly. I have turned feed to a minimum but program races to the end?
2: GViewer is not displaying the path only the tool; movement (It is showing in the KMotion CNC 3x DRO screen though)?

regards,
Vic

[TomKerekes]

Hi Vic,

1: How can I run a program slowly. I have turned feed to a minimum but program races to the end?

I don't understand what you mean. You might Single Step.

2: GViewer is not displaying the path only the tool; movement (It is showing in the KMotion CNC 3x DRO screen though)?

If a custom screen is in use you should close the separate GCode Viewer Screen and use the GCode Viewer Control on the main screen.