create a c program to run axes.

[irmad]

What are the uses of VAR?

and how, in one program g code there are 2 files?

[TomKerekes]

Hi irmad,

what causes the DAC to oscillate on CH0 and CH1?

Are you referring to dither? You might read this.

can i put a value of 0 on the dead band range and dead band gain?

See this.

velocity in the previous configuration, I set 700, does kmotioncnc automatically calculate when in kmotioncnc? if i want speed at g code F2100 (2100mm / min = 35mm / s).

If KMotionCNC is configured properly and in mm mode then F will be in mm/min

What are the uses of VAR?

See here and here.

and how, in one program g code there are 2 files?

To easily switch between files. Please don't use KMotion.exe's GCode Screen. It is obsolete. Use KMotionCNC instead.

[irmad]

why when testing at kmotion.exe, it is very accurate, but when running with kmotionCNC is not accurate, the difference is 1-2 mm.
What is wrong ?

[irmad]

I do not understand how to fill / rate this. please show me how.

[TomKerekes]

why when testing at kmotion.exe, it is very accurate, but when running with kmotionCNC is not accurate, the difference is 1-2 mm.
What is wrong ?

What are you doing in KMotion.exe and what are you doing in KMotionCNC.exe? What "difference" are you referring to?

I do not understand how to fill / rate this. please show me how.

See here. You can get to a explanation of any parameter yourself with just 2 mouse clicks: click Help, click the parameter

[irmad]

about axis parameter:
for example in kmotion I use V = 700, A = 3500, J = 350000. what value should I set in KmotionCNC for the Axis parameter?
does it have to follow the value in kmotion.exe?

[irmad]

and how, in one program g code there are 2 files?

To easily switch between files. Please don't use KMotion.exe's GCode Screen. It is obsolete. Use KMotionCNC instead.
[/quote]

I mean, for multiple g code files in 1 program.
Can it ? and how?

[TomKerekes]

about axis parameter:
for example in kmotion I use V = 700, A = 3500, J = 350000. what value should I set in KmotionCNC for the Axis parameter?
does it have to follow the value in kmotion.exe?

see here.

I mean, for multiple g code files in 1 program.
Can it ? and how?

No, a GCode Program is one file.

[irmad]

Sir, I still can't make the pedal function as a Cycle Start command, and halt. I want pedal number 1 (bit 137) when Normaly Close is Cycel Start, and when Normaly Open is Halt. can you write down the C program, so that I copy it in my C program.

[TomKerekes]

Hi irmad,

The ExternalButtons.c example has such an example of having an external input trigger Cycle Start. If you can't figure it out we offer personal programming support for a fee. Contact our support if you are interested. We charge $250/hr with a 2 hr minimum.