Kflop Cannot enable Axis

[men8ifr]

I'm just setting up my Kflop - I installed the latest Kmotion software 2 days ago - when I go into the axis selection and click to enable axis 0 I briefly see a tick and then a fraction of a second later it dissappears - it has switched the axis off.

I looked at the help but see no reference to tnot being able to enable an axis.

What could stop me enabling an axis?

I have another laptop with an older version (probably 2+ years old) and that works as expected

Kflop is connected when I try - otherwise you get messages Kflop is not connected (as expected)

I checked all other axis do the same as well.

Everything else appears to work as it should.

[men8ifr]

To add to this when I start Kmotion I get the error ---------------------------
KMotion
---------------------------
Error Status Record Size mismatch

Disable further status updates?
---------------------------
Yes No
---------------------------


Maybe this is related.

Also from the IO window I cannot select any bits as outputs

[TomKerekes]

Hi,

The Firmware Version Flashed in KFLOP and the KMotion Version must match. Answer Yes to disable status updates, flash New Version, then re start KFLOP and KMotion.exe.

HTH