PID Settings for KNozz Board

[AmitKumar171]

Hi Tom,

I am using Knozz board connected with kflop board.

I have connected thermistor Semitec 104GT2 100K ohm thermistor.

When is set the temperature of 200 degrees using m code i am not getting exact temperature. as you said it is 1degree accurate.

How to make it temperature and ADC count graph value accurate. ?

Or i have studied PID temperature control used by arduino board. Proportional Integrative Derivative (PID) Based temperature control is accurate but it is not available with current Knozz Board.

https://www.eurotherm.com/pid-control-made-easy

Above link explains PID based temperature control.

How to implement PID settings into Knozz Board.

Waiting for positive response.


Thank you

AMIT KUMAR

[TomKerekes]

Hi Amit,

You asked the same question here