Page 1 of 1
Saving of Work Offsets
Posted: Sun May 20, 2018 11:41 am
by EondeK
Hi
Which command can I use to save the parameters stored in the Work/Fixture offset table (G54, G55, etc).
Regards
Re: Saving of Work Offsets
Posted: Mon May 21, 2018 6:17 pm
by TomKerekes
Hi EondeK,
There isn't a command to explicitly save the offsets. But there is a "Save Always" option on the Edit Fixture Dialog that will automatically save the offsets to disk no matter how they are changed. Does this work for you?
Re: Saving of Work Offsets
Posted: Tue May 22, 2018 8:20 pm
by EondeK
Thanks, this should do it.
Re: Saving of Work Offsets
Posted: Mon May 28, 2018 5:48 am
by EondeK
Hi Tom
I checked and on the version I have, the Save Always tick box is not there. How do I add that?
Regards
Re: Saving of Work Offsets
Posted: Wed May 30, 2018 3:55 pm
by dynomotion
The "Save Always" option was added with version 3.34f. You can download the latest test release here:
http://www.dynomotion.com/wiki/index.ph ... are_Topics