The program for probe and toolsetter

[Alexanders]

It's time to connect probe and toolsetter. What examples can you recommend for working with them?
I found and started studying with an example \KMotion5.3.0\PC VC Examples\KMotionCNC\Screens\Probe_JB_Stig. However, these examples only use working with probe, without toolsetter. I would really like to find a complete mutual operation of these devices.
I will be very grateful, thank you!

[TomKerekes]

That depends on your job setup and use of offsets. The example ToolTableSet.c will set a tool table length such that the GCode DRO will read 0 with the tool tip touching the setter. Motion to probe the tool tip to the setter would need to be added for your tool setter.

You might also read this Thread.