Dynomotion Forum

Discuss KFLOP, Kanalog etc. here
https://dynomotion.com/forum/

KANALOG with SERVO DRIVER

https://dynomotion.com/forum/viewtopic.php?f=7&t=1689

Page 1 of 1

KANALOG with SERVO DRIVER

Posted: Thu Nov 09, 2023 3:11 am
by irmad
Hello, sir,
I hope you are healthy.
I want to ask, can the KANALOG board be connected to a PANASONIC brand servo driver?
because I want to install it on the flame cutting machine.

Re: KANALOG with SERVO DRIVER

Posted: Thu Nov 09, 2023 3:15 am
by TomKerekes
It depends on its specifications. Does it accept +/- 10V analog commands? Does it output differential encoder signals?
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/