Kogna Auto Disconnect - Requires Power Cycle

[TFrenken]

Hi Tom,

just wanted to give an update. All our Kogna's are version 1.3, we now use resistor and capacitor in parallel for all breakout boards that are more than about 1m distant from the KOGNA. After this we have no problems with Restarts anymore, the occasional disconnection problem was due to a problem with the hardware of the Laptop used. Since changing to a new setup it works fine.

Thank you for your support and for providing such a great and versatile control like KOGNA/KMotionCNC.

Regards,
Thomas

[TomKerekes]

Thanks Thomas for taking the time to post this.