Konga connection problem

[Yuhu_Li]

Dear Tom,

Due to some reason, I need to modify my PC's IPv4 addresss to 192.168.1.200 to control another device.

But when I modify my IPAddress, the board can't be connected. It runs normally when the PC's IP address is automatic discovery.

What should I do?

Best regards,

Yuhu Li
03/15/2026

[TomKerekes]

Hi Yuhu,

If you are manually assigning IP Addresses then you will likely need to assign Kogna’s IP address to something like 192.168.1.201. See here.