Tom,
I might have missed the documentation regarding the functionality of the Kogna Reset pin output.
I assume it remains at logic level low until the Kogna is booted and ready to connect ?
The intention is to drive an ssr which is in series with the drives / enable hardware.
Regards,
Tim
Kogna Reset output pin
Moderators: TomKerekes, dynomotion
-
TomKerekes
- Posts: 2711
- Joined: Mon Dec 04, 2017 1:49 am
Re: Kogna Reset output pin
Hi Tim,
The #Reset pin just pulses low on power up. It would probably be better to use an IO pin such as Bit16 on JP4 that has a pull down resistor that will be guaranteed to be low until set high by you in software after everything is initialized and configured.
The #Reset pin just pulses low on power up. It would probably be better to use an IO pin such as Bit16 on JP4 that has a pull down resistor that will be guaranteed to be low until set high by you in software after everything is initialized and configured.
Regards,
Tom Kerekes
Dynomotion, Inc.
Tom Kerekes
Dynomotion, Inc.