Tom/All
Is it possible to digitise a 3D part with dynomotion software and a touch probe?
2.5 / 3D digitisation
Moderators: TomKerekes, dynomotion
2.5 / 3D digitisation
My Set-up
PM30 Milling Machine - 3 axis
Kflop
Leadshine copy closed loop 'hybrid' stepper drivers similar to HBS86
Nema 34 6A 8.5Nm motors with encoder (encoder connects to stepper driver)
Fusion 360 Software
PM30 Milling Machine - 3 axis
Kflop
Leadshine copy closed loop 'hybrid' stepper drivers similar to HBS86
Nema 34 6A 8.5Nm motors with encoder (encoder connects to stepper driver)
Fusion 360 Software
-
TomKerekes
- Posts: 2676
- Joined: Mon Dec 04, 2017 1:49 am
Re: 2.5 / 3D digitisation
Hi men8ifr,
Well anything is possible. You might see this cnczone Thread and also this cnczone Thread.
Well anything is possible. You might see this cnczone Thread and also this cnczone Thread.
Regards,
Tom Kerekes
Dynomotion, Inc.
Tom Kerekes
Dynomotion, Inc.