lag in the DAC spindle output
Posted: Tue Apr 30, 2024 5:05 pm
so if i start the spindle at half speed 700 rpm
it will ramp right up. no trouble
now when i move the slider bar down in rpm, it is real slow even though the DAC is maxed in the opposite direction to slow the spindle
then if i hit "OFF" it takes about 2 second stop stop outputting the DAC
why is this?
i am feeling like there is a lot happening other than my commands
it will ramp right up. no trouble
now when i move the slider bar down in rpm, it is real slow even though the DAC is maxed in the opposite direction to slow the spindle
then if i hit "OFF" it takes about 2 second stop stop outputting the DAC
why is this?
i am feeling like there is a lot happening other than my commands