Page 1 of 1
Console Screen commands
Posted: Thu Jan 21, 2021 8:20 pm
by Scott Pancheau
Hi Tom,
Is it possible to enter a distance move from the console to check counts per inch?
Thanks,
Scott
Re: Console Screen commands
Posted: Thu Jan 21, 2021 8:47 pm
by curtiskelowna
you could certainly use the "move" command. If you think it should be 100 cts/inch, send that and see if it actually is. why not just use the MDI in kmotion CNC?
I think the "linear" command can command the machine to move in actual units with the trajectory planner but I could be wrong
Re: Console Screen commands
Posted: Fri Jan 22, 2021 3:11 pm
by Scott Pancheau
Got it, thanks for your help.
Scott