Dynomotion Forum

I studied Kflop at a screen resolution of 1920x1080. In the remote control of the machine, I put a touch screen monitor Asus VT168 with a resolution of 1366x768.
With this monitor, the KMotionCNC part is not visible vertically on the screen. I'm most interested in ProbeScreenSplit.scr, but it doesn't fit vertically either.
Please tell me how best to solve this problem.

Hi Alexanders,

You will need to modify the screen to the size you need.

There is an option to resize some or all the controls of a screen. See here.