Dynomotion Forum

Hello. Thanks for the add. I use kmotion on my cnc. I only use three axis and would like to increase some of the sizes on the basic 3 access screen. I cant get the screen editor to sync sync the cnc software. I keep getting this error. I have two computers on my machine. One as a back up. I cant edit in either computer I get the same error.......

Hi Corianman,

What Version of KMotion are you using?

What Version of Windows?

What Custom Screen Script did you load in KMotionCNC before running the Screen Editor?

4.34
Windows ten
I cleared the line for separating after selecting Custom like in your you tube video. I tried on three computers. All show the red X. No editor loads

I must have two user names. Oops. I’m Corianman also

Hi HotrodJohn,

I can't duplicate the error. Please try the following:

1. Disconnect any KFLOP
2. Fresh Install of KMotion 4.34
3. Run KMotionCNC.exe
4. Tool Setup | Set Dialog Face to Custom and blank Screen Script File name
5. Run KMotionCNCScreenEditor.exe

Microsoft Windows displays a Red X when there is a call to an OpenGL Graphics Function that has an Error. The Red X can appear if OpenGL is not supported on the computer. But more likely is caused by something like an invalid/corrupted Screen Script file resulting in something invalid being attempted.

You might run GLView to test the OpenGL on your PC.