Konnect causes reboot
Posted: Fri Jul 05, 2024 8:28 am
Ive connected a Konnect and Kstep to a Kogna
Motors and Kstep IO working as expected
adding InitAux() & AddKonnect(0,&VirtualBits, VirtualBitsEx) to init program
Running KMotion App outputs can be controlled and LED's come on/off on the KOnnect board.
All is good and stable after initial power up. Turn just one LED on and 1 minute later the Kogna reboots.
100% repeatable. Always the same delay before reboot.
V5.3.3
Motors and Kstep IO working as expected
adding InitAux() & AddKonnect(0,&VirtualBits, VirtualBitsEx) to init program
Running KMotion App outputs can be controlled and LED's come on/off on the KOnnect board.
All is good and stable after initial power up. Turn just one LED on and 1 minute later the Kogna reboots.
100% repeatable. Always the same delay before reboot.
V5.3.3