Dynomotion Forum

Hi tom,

I am using 4.35e, version of kmotiocnc, i found one bug, when i open on G-code in kmotioncnc, then when i close kmotioncnc and reopen it again, it is not opening same program automatically. it was opening previously loaded program in 4.34, but it is not doing in 4.34e.

waiting for your feedback and correction of the above bug please.

Waiting for your kind reply.

Hi Amit,

I can't reproduce this problem. What steps are you doing?

The filenames are saved in \KMotion\Data\GFilesCNC.txt

Is the last file listed in that file correctly after exiting KMotionCNC?