KFLOP REV 1.3 does not start

Demon-k2008 · Post by **Demon-k2008** » Wed Feb 26, 2025 5:30 am

Hello. We purchased several KFLOP cards. One does not start. All the voltages are present. The LEDs do not turn on after the power supply is connected. There is generation on the processor. There is access to flash memory, but after accessing the memory, everything stops, and the pulses remain only on the generator. Can you provide the firmware that is in the 39VF1602C?

Demon-k2008 · Post by **Demon-k2008** » Wed Feb 26, 2025 5:50 am

The PC does not see the connection.

Post by **TomKerekes** » Wed Feb 26, 2025 5:51 am

Hi Demon,

Sorry you are having problems.

We don’t find it cost effective to repair KFLOPs

We don’t release the image for the Flash memory.

Demon-k2008 · Post by **Demon-k2008** » Wed Feb 26, 2025 6:06 am

TomKerekes wrote: ↑
Wed Feb 26, 2025 5:51 am
We don’t release the image for the Flash memory.

Do you know where to apply for the firmware?

Post by **TomKerekes** » Wed Feb 26, 2025 3:09 pm

No sorry we don’t release that.

If you send us the board we can attempt to reprogram. If that’s the problem then we can return it for shipping cost.

Dynomotion Forum

KFLOP REV 1.3 does not start

KFLOP REV 1.3 does not start

Re: KFLOP REV 1.3 does not start

Re: KFLOP REV 1.3 does not start

Re: KFLOP REV 1.3 does not start

Re: KFLOP REV 1.3 does not start