Dynomotion Forum

Tom,
I have attached a screen shot of my 8 axis screen.
on Fed hold two sets of arrows are displayed.
Where do they come from and how can i remove them please ?
I have included a zip file of the new buttons we have created, please feel free to include in future versions.

Is there a way to run a portion / section of G code program from a specific line or postion in a program ?

Regards,
Tim

Hi Tim,

on Fed hold two sets of arrows are displayed.
Where do they come from and how can i remove them please ?

This is a powerful feature of KMotionCNC which is the ability to move forward and backward along the GCode Path while in Feed Hold. They automatically become visible while in Feed Hold. We don't currently have a way to disable this. You could move them outside of your screen area to make them invisible.

I have included a zip file of the new buttons we have created, please feel free to include in future versions.

Thank you!

Is there a way to run a portion / section of G code program from a specific line or postion in a program ?

You can begin execution from a specific line of GCode by right clicking on the line of GCode and selecting 'Set Next Statement'. There are some restrictions on this and it up to the Operator to make sure its appropriate whereas the correct Fixture, Tool, etc. is selected.