Spindle/KmotionCNC
Posted: Wed Jun 07, 2023 5:32 pm
Hi Tom,
One other question about spindle speed. On the PC screen of Kmotion, if I command the spindle to a speed, the commanded speed shows up in the top box next to the letter S above the Spindle Slider. However, the lower box says zero. If I move the slider up or down the speed of the spindle changes (on the inverter DRO) but the KmotionCNC screen still reports the original commanded speed and the box below it says zero. How do I get that lower box to show the actual adjusted speed, i.e., if the slider is adjusted to 50% the lower box would read 50% of the original commanded speed?
Jack
One other question about spindle speed. On the PC screen of Kmotion, if I command the spindle to a speed, the commanded speed shows up in the top box next to the letter S above the Spindle Slider. However, the lower box says zero. If I move the slider up or down the speed of the spindle changes (on the inverter DRO) but the KmotionCNC screen still reports the original commanded speed and the box below it says zero. How do I get that lower box to show the actual adjusted speed, i.e., if the slider is adjusted to 50% the lower box would read 50% of the original commanded speed?
Jack