Dynomotion Forum

Posted: **Tue Feb 21, 2023 10:57 am**

Dear sir,
I have been facing an issue that whenever I open my KMotion CNC Application, by default the DRO value units in Inches.
Is it possible to change the Default unit of Kmotion CNC to mm.

Regards,
Ajith Arawinth

Posted: **Tue Feb 21, 2023 5:50 pm**

Hi Ajith ,

You can control the Interpreter initial settings with the Setup File.

Posted: **Wed Feb 22, 2023 4:36 am**

Dear Sir,
Thanks for your Guidance

Dynomotion Forum

setting the DRO unit in mm

setting the DRO unit in mm

Re: setting the DRO unit in mm

Re: setting the DRO unit in mm