RTCP Kinematics
Posted: Wed Oct 21, 2020 5:30 pm
Tom,
Can you please check 4.35d Kmotion CNC kinematics .txt works with a varying pivot to chuck length entry.
I have just run the attached program that should keep the tool tip at a constant zero position.
If i change the pivot to chuck length entry in the kinematics.txt file attached it does not make any difference to the way the tip moves, in that it moves off the centre zero position regardless of the value entered.
It may be the format of entry for the length.
Regards,
Tim
Can you please check 4.35d Kmotion CNC kinematics .txt works with a varying pivot to chuck length entry.
I have just run the attached program that should keep the tool tip at a constant zero position.
If i change the pivot to chuck length entry in the kinematics.txt file attached it does not make any difference to the way the tip moves, in that it moves off the centre zero position regardless of the value entered.
It may be the format of entry for the length.
Regards,
Tim