Dynomotion Forum

Hi Tom, Thanks for the reply as you have said earlier I did edited KmotionCNCscreen editor to use DIVIDE KEY and MULTIPLICATION KEY to set keyboard jog for my c axis. I have set the key according to the sceenshot attached. But i am not able to run the C axis with above keyboard buttons. Is there any...

Hi All, I am using KMotion Board. And in KmotionCNC software there are jog buttons are there respectively for X, Y, Z, A, B, C axes. And Shortcut Commands are there for Step/Fast Jog Only 4 of 8 axes. like X, Y, Z, A. How do i add more shortcuts to drive axes like B, C, U, V to Step/Fast Jog similar...

Hi Tom, I am using Knozz board connected with kflop board. I have connected thermistor Semitec 104GT2 100K ohm thermistor. When is set the temperature of 200 degrees using m code i am not getting exact temperature. as you said it is 1degree accurate. How to make it temperature and ADC count graph va...

Hi Everyone,

I am using knozz board with kflop board.

And in setting the temperature for heater on knozz board. I have to go to Kmotion console for temperature update.

I want the same temperature update on KmotionCNC screen where all axes and DRO buttons are.