Dynomotion Forum

Hi Tim, Yes the Motion Buttons (Jog Buttons) are special and are updated dynamically based on a Job Running and such. Here is a patch for V5.4.1 that will allow forcing enable/disable by setting the Var parameter of the Control with Screen Script. Here is an example: #include "KMotionDef.h" #define ...

Hi Thomas, Thanks for the update. During testing I noticed that my KOGNA ground (soft ground with 1K Ohm resistor and 10nF capacitor) varied from my overall ground/earth of the system in times quite a lot Was the resistor and capacitor in parallel? I switched KOGNA to one hard ground and using capac...

Hi Tim, i randomly get software limit activation What do you mean by this? A Console Message? Popup Message? When you Jog? AdjustSoftlimits.c triggers a Feed Hold while Jogging. You might use KMotion and upload the Axis to view the parameters and check if Soft Limits are correct. It isn't clear rega...

Hi Thomas, Sorry for the problems, we are determined to resolve this. But difficult as we can't re-produce it. Any additional info or clues on the issue would be appreciated. I cut the #RESET wire on another machine, and it helped bit did not solve the problem completely. Did you cut the wires on al...

Hi Thomas, So shorting #RESET to 3.3V stops any disconnects for you? Could you provide more details? Where are you shorting it? Could you try cutting the #RESET wire near the Kogna Connectors to see if that also solves the problem? Another option would be to add a small Ceramic Cap (0.01uF) between ...

Hi Tim, If the Probe is triggered calling StopCoordinatedMotion() continuously should stop and prevent any motion. However it would require the probe signal to be removed to allow any motion away from the probe. There isn't any clear way to determine which axis and which direction caused the trigger...

Hi Tim, The Red bar is normally used to show that actual measured spindle speed. It reads the Axis configured for the Spindle. Set the Threading Sensor Type to 0 (none) to disable this. Normally to do Probing an axis is commanded to do an independent Jog and then a C Program loops watching the Probe...

Hi Griffin, One possibility is a noise glitch entering the peripheral RESET# signal that is on several connectors. Crosstalk on cables might cause a reset. The signal is an output only signal that is driven hard to 3.3V. If I short it to GND through a 10 Ohm resistor it causes the Ethernet to discon...

Hi Tim, I need a slider to control the glue dispense time as the lue viscosity varies depending on the factory temperature. The glue secures the placed inserts in the mould to stop them moving when the mould is filled with concrete. I was hoping to read the spindle override slider and scale to the c...

Very nice!