Dynomotion Forum

Hi Tom, I have tested the new patch and the "Rapids as Feeds" option, with very positive results! the gcode path now plays smoothly and perfectly, without the previuos issues! YOUR SUPPORT IS GREAT AND THIS IS A LITTLE SIGN OF GRATITUDE: https://youtu.be/qFQfnAsJh3g thank you again! have a nice we dd

Thank you very much Tom!
I will try the new gcodeinterpreter.dll and let you know asap,
so if I turn on "Rapids as Feeds", the G0 FR is determined by the axis parameters (vel/acc/jerk) inside the init.c file, correct?
thanks again
dd

Hi Tom, continuing testing the new SW trajectory planner, I have found the following issues, playing the attached 5 axis path: - rapid moves (with all 5 axis involved) sometimes exceeds the maximum linear axis setup (both in init.c and kmotioncnc trajectory planner axis parameters): for example if y...

Hi Tom, I have tested your new GCodeInterpreter.dll and it works great! Also break angle works with previous cylinder gcode, and according to your advice I put 179 degrees value to optimise the path. I agree with your modifications in kinematics tolerance, also because I normally mill wood materials...

Thank you very much Tom!
I will test everything in the we and let you know,
all my best
dd

Hi Tom thanks for your support, please find attached my kinematics files including txt with constants (I have 2 possible horizontal mill configurations depending of the A axis home position: AC or AB "selfmade"), in both cases my 0 Machine is the center of rotation axis (AB or AC) so the constants a...

Hi Tom, I have some issues with 5 axis continous gcodes, in terms of sustainable feed rate: - please find attached a simple square inclined 5 axis swarf profile gcode, in the path corners the feed rate slows down dramatically depending on the mm/min feed rate indicated in line #8 of the gcode, to a ...

Thanks Tom Maybe to visualize a crash if such a motion is made? yes it is for this reason please take a look to this italian company site, they produce similar controllers with included an advanced simulator where you can build your machine graphics according to the kinematics in order to check poss...

Hi Tom, coming back to the GViewer simulation in kmotioncnc for 5axis RTCP ngc output by the cam sw, this is my experience: every 5 axis rtcp milling cycle gcode loaded is always plotted in the same way (CAM correct way) with or without the G43.4 Hxx command, (as you confirmed the viewer does not kn...

Thank you Tom,
dd