Dynomotion Forum

I use Mach3, Kflop & KAnalog, when run a program after 10 minutes they lost approx 1/3 of feed speed,

Well, I test servos and drivers and move to DAC output #2 and test position and measures, in this output no have problem.... the problem is in the DAC output #1...
how re_define outputs?
X = DAC #0
Y = DAC #2
Z = DAC #3
C = DAC #4

Spindle is DAC #7

Regards

Hi, when move the machin they loose position, when I try to make a radius use position in center and when apply G02, the machine move to one extreme in position but when move at the other side has 15mm moved or displaced, when back to the first side they back with the difference 15 mm aprox displace...

I read the manual, in my macro instead antivate one signal, I change the syntax and write NotifyPlugins (10xxx) and create a Notify that SetBit or ClearBit??

This Rover have 36 bit drill positions, 15 cone holders (ISO30), 3 spindle, 1 spindle 90° that can rotate 360°, 1 spindle circular saw can rotate 90°. Well I use a PLC to Multiply outputs using binary configuration, My principal Spindle Is only One, I would like to use the circular saw, all tools po...

I have a macro that use in Mach3, I need outputs to activate solenids to down bit drills and up tool holders, to libery tool from spindle motor, etc.

Hi, I have Kflop + KAnalog with mach3, in a Router Biesse Rover 346, servos and drives Yaskawa analogs +- 10V, they has been configured and work well but when I try to configure an OUTPUT in Mach3 they not work and in some times an axis begins to move, my first intention is control the outputs to co...