Dynomotion Forum

Thanks Tom

Problem solved it was due to using a dual power supply 5v and 24v.
Now using individual supplies and all seems well.

Regards

Art

Hi Tom

Yep Kflop rebooted relay dropped out.

Going to try a separate 5v power supply incase there is a drop in 5v when relay triggers. (Its not visible on meter and I don't have my scope handy)

Art

Hi Tom

I forgot that I had changed from SWE to Fet 0 O/P and I have a diode across the relay. I have also moved the relay from the kflop enclosure to be close to the drives.
I am not sure what you mean by turning off a kflop led?

Regards

Art

Hi Tom All axis are working well and the router has been running g code both in kmotioncnc and mach3. This was with the 24v to enable the servo amps hard wired. The only problem was that on power up the servo's started moving until kmotion or mach was initialsed. I then fitted a relay to switch the ...

Thanks Tom

That's it working on the x axis. Just need to add the other axis's again.
I had edited program to home only the x axis and noticed the missing semicolon and comma.

Regards

Art.

Hi Tom, I have all 3 axis working and calibrated in Mach3 but having problems with homing. Homing is disabled in mach3 and I am using a home c prog found on the forum as a starting point. When I ref all I get a compilation error. I am only trying to home Z at the moment. I am using pnp hall effect s...

Hi Tom, I was unable to find the original posts in the forum so this has turned out to be a new setup using windows 10 as the old PC would not come back to life. The machine is a simplec 3 axis router using parker servo's and drive's. Spindle will just be a relay switching router on and off. I have ...

Hi Tom

Is there any way in finding my old forum posts from September October 2010 so that I can figure out my old settings?

Regards

Art

Hi Tom

I have decided to complete a part built router I started nearly 10 years ago using kflop & Kanalogue running Parker drives and servo's on kflop v4.22.
Will there be any problems upgrading to the latest firmware?

Arthur