Dynomotion Forum

Hi Tom,
You are the one that had the patience.
I learned something.
Thank you
Bernie

Hi Tom,
Hurrah, hat was the solution.
Usually I did check the sub directory box, but then I always selected the i386 directory.
I have the 64 bit version of Win10. I do wonder why pointing directly at Dynoprt.inf does not work.
Thank you so much.
Bernie

Hi Tom, Here are some screen shots. devman3.png devman5.png When I click on the i386 folder no .inf file becomes visible. When I use file explorer to look at the contents of the i386 folder I do see dynoport.inf. When I right-click on dynoport.inf and then on "install", it gets installed but does't ...

Thanks Tom,
My KMotion is version 4.34 and I do have administrator privileges.
Bernie

Hi Tom, Here are some screen shots. devman1.png devman2.png I then click uninstall, unplug the USB and plug it back in. After KFLOP stops blinking windows tells me "that it is setting up the KFLOP Motion Controller, and then, " device is ready - KFLOP Motion Controller is set up and ready to go" The...

Hi Tom,
Yes, I am following those instructions. This may not have anything to do with my driver problems: I just received the board 2 days ago. Does it have the latest firmware on it? I downloaded KMotion just about two weeks ago. How do I find out what version I have?
Bernie

I am unable to get the USB driver working with KFLOP in Windows 10. When I connect KFLOP to a USB port after uninstalling the non functioning driver, Windows tells me "we're setting up KFLOP motion controller" and then, after a second or two, "KFLOP motion controller is set up and ready to go". When...

I am in the process of converting my Mitutoyo Millstar equipped 2 axis mill. The current setup uses Mitutoyo AT100 series linear encoders. According to Mitutoyo the encoders put out a 2 volt peak to peak sine wave quadrature signal on 2 wires (plus ground). There is no mention of a differential sign...

Thank you very much. I will be ordering a KFLOP board today.

Is there a list of connector types for use with the KFLOP board anywhere?