Sir:

I purchased your Kflop and Kenalog boards to run a waterjet we have built. When I first configured this I had no trouble tuning the servos and running G code programs. We sense installed a dedicated pc in the nema enclosure on the machine and I installed the latest version of your software. I was unable to move the settings by copying the specified directory, but tuned the servos again. Am able to execute c code fine without problems.
When I try to run the Kmotion CNC program I initialize the program with the same c program that I use in Kmotion executive. The CNC module however continues in some direction and is unresponsive to anything other than hold. I would imagine that some Initialization or homing routine is being executed from some location I am not seeing. Could you tell me where this might be?

Thank you very much,

Fayette Sims